Protocol analysis
R&S
®
RTO6
702User Manual 1801.6687.02 ─ 05
Remote command:
SEARch:
TRIGger:MILStd:
ERRor:MANChester on page 1978
SEARch:TRIGger:MILStd:ERRor:PARity on page 1978
SEARch:TRIGger:MILStd:ERRor:SYNC on page 1978
SEARch:TRIGger:MILStd:ERRor:TIMing on page 1978
13.12.5.2 MIL search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
The serach results are the same as Chapter 13.12.4, "MIL-STD-1553 decode results",
on page 698
Remote commands:
●
SEARch:RESult:MILStd:WCOunt? on page 1980
●
SEARch:RESult:MILStd:WORD<m>:INFO? on page 1982
●
SEARch:RESult:MILStd:WORD<m>:RTADdress? on page 1982
●
SEARch:RESult:MILStd:WORD<m>:STARt? on page 1981
●
SEARch:RESult:MILStd:WORD<m>:STATus? on page 1980
●
SEARch:RESult:MILStd:WORD<m>:STOP? on page 1981
●
SEARch:RESult:MILStd:WORD<m>:SYMBol? on page 1981
●
SEARch:RESult:MILStd:WORD<m>:TYPE? on page 1980
13.13 ARINC 429 (option R&S RTO6-K530)
13.13.1 ARINC 429 basics
The ARINC 429 is a specification that defines the characteristics of an avionic data bus
used on commercial and transport aircraft.
In an ARINC 429 system, a single transmitter/source is connected to 1 to 20 receivers/
sinks on one twisted wire pair. The bus uses differential signals. The ARINC 429 stan-
dard uses a simplex communication - data may be transmitted in only one direction.
The information is transmitted over the bus in defined series of words.
ARINC 429 (option R&S R
T
O6-K530)
To Next Page
Loading...
