R&S RTO6 - 24.26 Status reporting; 24.26.1 STATus:OPERation register

Remote control commands
R&S
®
RTO6
2572User Manual 1801.6687.02 ─ 05
Return values:
<State> PSSD | FAILed | UNDefined
*RST: UNDefined
Usage: Query only
Asynchronous command
DIAGnostic:SERVice:PWD <Password>
Sets the password to enter the service mode.
Setting parameters:
<Password> Password string
Usage: Setting only
Asynchronous command
24.26 Status reporting
This chapter describes the remote commands that are used to read the status regis-
ters.
For information on structure, hierarchy
, and contents of the status registers, see Chap-
ter 22.5.4, "Remote control - status reporting system"
, on page 1245.
● STATus:OPERation register................................................................................2572
● STATus:QUEStionable registers......................................................................... 2573
24.26.1 STATus:OPERation register
STATus:OPERation commands provide information on the activity of the instrument.
See also: "STATus:OPERation register" on page 1246
STATus:OPERation:CONDition?....................................................................................2572
STATus:OPERation[:EVENt]?........................................................................................2572
STATus:OPERation:ENABle..........................................................................................2573
STATus:OPERation:CONDition?
STATus:OPERation[:EVENt]?
The CONDition command returns information on actions the instrument is currently
executing. The contents of the register is retained.
The EVENt command returns information on actions the instrument has executed
since the last reading. Reading the EVENt register deletes its contents.
Bits:
●
0 = ALIGnment
●
2 = AUToset
Status reporting