Protocol analysis
R&S
®
RTO6
577User Manual 1801.6687.02 ─ 05
Remote command:
SEARch:
TRIGger:CMSB:
ERRor<m>:ENABle on page 1785
SEARch:TRIGger:CMSB:FIENable on page 1785
SEARch:TRIGger:CMSB:FRAMe<m>:ENABle on page 1787
SEARch:TRIGger:CMSB:FRENable on page 1785
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:BIT on page 1785
SEARch:TRIGger:CMSB:BIT on page 1785
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:DMAX on page 1786
SEARch:TRIGger:CMSB:DMAX on page 1786
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:DMIN on page 1786
SEARch:TRIGger:CMSB:DMIN on page 1786
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:DOPerator on page 1787
SEARch:TRIGger:CMSB:DOPerator on page 1787
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:IMAX on page 1788
SEARch:TRIGger:CMSB:IMAX on page 1788
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:IMIN on page 1788
SEARch:TRIGger:CMSB:IMIN on page 1788
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:IOPerator on page 1788
SEARch:TRIGger:CMSB:IOPerator on page 1788
Error Condition
Searches for two error conditions: "CRC Error" or "Parity Error".
Remote command:
SEARch:TRIGger:CMSB:ERRor<m>:ENABle on page 1785
13.6.6.2 Custom serial bus search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands are listed in Chapter 24.17.7.6, "Search results", on page 1789
13.6.6.3 Searching custom serial bus data
Prerequisite: A serial bus is configured for the custom serial bus signal to be decoded
and analyzed.
The search for events is set up in the following way:
1. Press the [Bus] key and selet the "Shortcuts" tab.
2. Tap "Setup search".
Custom: Manchester / NRZ (option R&S R
T
O6-K510)
To Next Page
Loading...
