R&S RTO6 - 19.4 Control loop

Power analysis (option R&S RTO6-K31)
R&S
®
RT
O6
1150User Manual 1801.6687.02 ─ 05
Frequency
Selects the frequency of the input signal.
Remote command:
POWer:
HARMonics:
ENFR on page 2531
POWer:HARMonics:MIFR on page 2532
POWer:HARMonics:DOFR on page 2531
Revised Current
Available only for "Standard" > "RTCA DO-160".
Selects how the results are evaluated. Available are the following settings:
●
Evaluation with current source only
●
Evaluation with voltage source and revised current law
– Display opposite voltage harmonic result chart
– Do not display voltage result
Remote command:
POWer:HARMonics:EVAL on page 2532
POWer:HARMonics:VOLT on page 2533
Optimize scaling
Selects the scaling for the display of the results.
"Autoscale the signals"
Automatically selects the most appropriate scale for the display of the
results.
"Keep present settings"
The present display settings are not changed.
Remote command:
POWer:HARMonics:
AUTO on page 2531
Report comment
In this field you can write a comment that is displayed in the measurement report, for
example, a measurement description.
Execute
Starts the "Current Harmonics" measurement.
Remote command:
POWer:HARMonics:EXECute on page 2532
19.4 Control loop
Access: [App Cockpit]> "Analysis" > "Power" > "Control Loop"
Control loop