Measurements
R&S
®
RTO6
366User Manual 1801.6687.02 ─ 05
The settings are only visible if "Limit check" is enabled.
Remote command:
MEASurement<m>:
AMPTime:
LCHeck<n>:LOWer:LIMit on page 1499
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:MARGin on page 1499
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:LIMit on page 1499
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:MARGin on page 1499
MEASurement<m>:AMPTime:LCHeck<n>:VALid on page 1498
To check limits and margins of jitter measurements, use the AMPTime remote com-
mands.
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:LIMit on page 1510
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:MARGin on page 1511
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:LIMit on page 1510
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:MARGin on page 1511
MEASurement<m>:EYEJitter:LCHeck<n>:VALid on page 1510
MEASurement<m>:HISTogram:LCHeck<n>:LOWer:LIMit on page 1530
MEASurement<m>:HISTogram:LCHeck<n>:LOWer:MARGin on page 1531
MEASurement<m>:HISTogram:LCHeck<n>:UPPer:LIMit on page 1530
MEASurement<m>:HISTogram:LCHeck<n>:UPPer:MARGin on page 1531
MEASurement<m>:HISTogram:LCHeck<n>:VALid on page 1530
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:LIMit on page 1517
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:MARGin on page 1518
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:LIMit on page 1517
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:MARGin on page 1518
MEASurement<m>:SPECtrum:LCHeck<n>:VALid on page 1517
8.2.13.3 Actions on limit check results
To define what happens when the limits and margins are exceeded, tap Action on limit
event below the limit and margin ranges.
Actions are initiated by all measurements and all results measured on one acquisition.
Note that the violation actions do not distinguish between a margin violation and a limit
violation. However, dif
ferent icons are displayed in the result box.
Automatic measurements
To Next Page
Loading...
