R&S RTO6 - Page 1498

Remote control commands
R&S
®
RTO6
1498User Manual 1801.6687.02 ─ 05
Parameters:
<DlyTrigSlp> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
MEASurement<m>:AMPTime:DTOTrigger<n>:LSELect <DlyTrigLevSel>
Selects the reference level of the measurement source on which the delay is mea-
sured.
Suffix:
<m>
.
1..10
See
"Selection of the measurement group: MEASurement<m>"
on page 1479.
<n> 1..2
The suffix is irrelevant.
Parameters:
<DlyT
rigLevSel> UPPer | MIDDle | LOWer
*RST: MIDDle
Usage: Asynchronous command
MEASurement<m>:AMPTime:LCHeck<n>:VALid <ValidRange>
Enables or disables limit checking for amplitude vs. time measurements in the speci-
fied measurement channel.
Suffix:
<m>
.
1..10
See
"Selection of the measurement group: MEASurement<m>"
on page 1479.
<n> 1..50
Number of the amplitude/time measurement, see Table 24-6.
Parameters:
<V
alidRange> ILIMit | ULIMit | LLIMit | OLIMit
ILIMit
Inside (within) limit; between the upper and lower limit values
ULIMit
Upper limit; above the upper limit value
LLIMit
Lower limit; below the lower limit value
OLIMit
Outside limit; above the upper limit or below the lower limit val-
ues
*RST: ILIMit
Usage: Asynchronous command
Automatic measurements