Remote control commands
R&S
®
RTO6
1490User Manual 1801.6687.02 ─ 05
In addition, the suffixes <n> for limit-check remote commands are listed.
For a detailed description, see Chapter 8.2.5.1, "Overview of amplitude/time measure-
ments", on page 316
.
T
able 24-6: Amplitude and time measurements
<MeasType>
parameter value
(remote control)
Measurement
(manual opera-
tion)
Description, result Suffix
<n>
HIGH High High signal level 1
LOW Low Low signal level 2
AMPLitude Amplitude Amplitude of the signal 3
MAXimum Max Maximum value of the waveform 4
MINimum Min Minimum value of the waveform 5
PDELta Peak to peak Peak-to-peak value of the waveform 6
MEAN Mean Mean value of the waveform 7
RMS RMS RMS (Root Mean Square) value of the voltage 8
STDDev σ (S-dev) Standard deviation of the waveform 9
POVershoot Pos. overshoot Positive overshoot of a square wave 10
NOVershoot Neg. overshoot Negative overshoot of a square wave 11
AREA Area Area beneath the waveform (integral) 12
RTIMe Rise time Rise time of the left-most rising edge of the waveform. 13
FTIMe Fall time Falling time of the left-most falling edge of the waveform. 14
PPULse Pos. pulse Width of a positive pulse – a rising edge followed by a
falling edge. The measurement requires at least one
complete period of a triggered signal.
15
NPULse Neg. pulse Width of a negative pulse –
a falling edge followed by a
rising edge. The measurement requires at least one
complete period of a triggered signal.
16
PERiod Period Length of the left-most signal period of the waveform
17
FREQuency Frequency Frequency of the signal. The result is based on the
period measurement.
18
PDCYcle Pos. duty cycle Positive duty cycle. The measurement requires at least
one complete period of a triggered signal.
19
NDCYcle Neg. duty cycle Negative duty cycle. The measurement requires at least
one complete period of a triggered signal.
20
CYCarea Cycle area Area (integral) beneath one cycle 21
CYCMean Cycle mean Mean value of one cycle 22
CYCRms Cycle RMS The RMS (Root Mean Square) value of one cycle 23
CYCStddev Cycle σ (S-dev) Standard deviation of one cycle 24
Automatic measurements
To Next Page
Loading...
