R&S RTO6 - 24.16.5 Waveform histogram export to file

Remote control commands
R&S
®
RTO6
1656User Manual 1801.6687.02 ─ 05
Usage: Asynchronous command
EXPort:WAVeform:DISPlayoff <FastExport>
Enables or disables the display update during an Nx Single acquisition.
Parameters:
<FastExport> ON | OFF
ON: Disables the display update for maximum export speed.
OFF: Enables the display update. The export is slower.
*RST
: OFF
Usage: Asynchronous command
EXPort:WAVeform:FASTexport <Enable>
To improve the performance of data export to file, the measurements are performed
slower while the data export speeds up.
Setting parameters:
<Enable> ON |
OFF
Example: See Chapter 24.3.5.2, "Exporting waveform data to file",
on page 1267
Usage: Setting only
Asynchronous command
24.16.5 Waveform histogram export to file
EXPort:HIST
ogram:SELect............................................................................................1656
EXPort:HISTogram:INCidence.......................................................................................1656
EXPort:HISTogram:NAME.............................................................................................1657
EXPort:HISTogram:SAVE..............................................................................................1657
EXPort:HISTogram:DATA?............................................................................................1657
EXPort:HISTogram:SELect <Name>
Selects the histogram to be exported.
Parameters:
<Name> String with the histogram name.
Example: See "Exporting histogram data to file" on page
1264
Usage: Asynchronous command
EXPort:HISTogram:INCidence <Incidence>
Sets the mode of exported data: relative or absolute frequency of amplitude values.
Data management