R&S RTO6 - 24.16.8 Screenshots

Remote control commands
R&S
®
RTO6
1660User Manual 1801.6687.02 ─ 05
Parameters:
<Path> String with path and file name. The file extension defines the file
format: XML, CSV
, or BIN.
Example: See
"Exporting long-term measurement data to file"
on page 1264
Usage: Asynchronous command
EXPort:MEASurement:SA
VE
Saves the long term or measurement histogram results to the file specified using
EXPort:MEASurement:
NAME.
The measurement data can be exported as absolute or relative values, which is
defined using EXPort:HISTogram:INCidence.
Example: See "Exporting long-term measurement data to file"
on page 1264
Usage: Event
EXPort:MEASurement:DATA?
Transfers the long term measurement data to the controlling computer. The data can
be used in MA
TLAB, for example. The transferred data are the same as the data writ-
ten to files.
To set the export data format, use FORMat[:DATA].
Return values:
<Data> List of values according to the format settings
Long term data:
If statistics are disabled, the current value of each long term
point is returned.
If statistics are enabled (MEASurement<m>:STATistics[:
ENABle]), seven values for each long term point are returned:
upper peak, lower peak, RMS, standard deviation, average,
number of measured results per long term point, number of
waveforms per long term point.
For measurement histograms, absolute values are returned.
See also:
Chapter 12.2.5, "Result plots analysis", on page 469.
Example: See "T
ransferring long-term measurement data"
on page 1265
Usage: Query only
24.16.8 Screenshots
The HCOPy subsystem and some other commands control the output of display infor-
mation for documentation purposes. The instrument allows two independent output
configurations which can be set separately with the suf
fix.
Data management