R&S RTO6 - 24.8.5 Vertical

Remote control commands
R&S
®
RTO6
1337User Manual 1801.6687.02 ─ 05
Parameters:
<ReplayAfterAcq> ON | OFF
*RST: ON
Usage: Asynchronous command
24.8.5 V
ertical
CHANnel<m>:
STATe.................................................................................................... 1337
CHANnel<m>:COUPling...............................................................................................1337
CHANnel<m>:GND...................................................................................................... 1338
CHANnel<m>:SCALe................................................................................................... 1338
CHANnel<m>:RANGe.................................................................................................. 1338
CHANnel<m>:POSition.................................................................................................1339
CHANnel<m>:OFFSet..................................................................................................1339
CHANnel<m>:INVert.................................................................................................... 1339
CHANnel<m>:BANDwidth.............................................................................................1340
CHANnel<m>:CPLing...................................................................................................1340
CHANnel<m>:IMPedance.............................................................................................1340
CHANnel<m>:OVERload.............................................................................................. 1341
CHANnel<m>:FILDesign...............................................................................................1341
CHANnel<m>:STATe <State>
Switches the channel signal on or off.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
CHANnel<m>:COUPling <V
alue>
Selects the connection of the indicated channel signal.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<V
alue> DC | DCLimit | AC
DC
Direct connection with 50 Ω termination, passes both DC and
AC components.
Acquisition and setup