R&S RTO6 - 13.17.2.2 Advanced settings

Protocol analysis
R&S
®
RTO6
759User Manual 1801.6687.02 ─ 05
BUS<m>:RFFE:DATA:THReshold:HIGH on page 2056
BUS<m>:
RFFE:DATA:
THReshold:LOW on page 2057
BUS<m>:RFFE:DATA:THReshold:HYSTeresis on page 2057
BUS<m>:SETReflevels on page 1671
BUS<m>:FAUToset on page 1671
Show thresholds
If enabled, the threshold levels are displayed in the diagram.
Remote command:
BUS<m>:THReshold on page 1671
13.17.2.2 Advanced settings
Access: [Bus] > "Advanced" tab.
Autoset
Starts software algorithms for determining the signal threshold levels and bitrate.
Remote command:
BUS<m>:FAUToset
on page 1671
Glitch filter
Enables the glitch filter on the SCLK and SDATA lines to improve decode accuracy.
The "Glitch filter width" field sets the maximum glitch width to be ignored.
Remote command:
BUS<m>:RFFE:GFILter on page 2058
BUS<m>:RFFE:GFWidth on page 2059
Timing
The gap defines the idle time between the Bus Park Cycle (BP) and Sequence Start
Condition (SSC).
You can define a "Min gap time". The standard defines a minimum of 10 ns to separate
two subsequent command sequences.
RFFE (option R&S R
TO6-K550)