Protocol analysis
R&S
®
RTO6
771User Manual 1801.6687.02 ─ 05
Remote commands
Remote commands to retrieve decode results are described in Chapter 24.17.18.3,
"Decode results", on page 2069
.
13.17.6
Search on decoded RFFE data
Using the search functionality, you can find various events in the decoded data, the
same events which you also can trigger on. Before you can start the search, you have
to configure the bus correctly and acquire decoded data.
To search on decoded data, set the search "Source" to the serial bus that is configured
for the protocol to be analyzed.
See also Chapter 11, "Search functions", on page 419.
13.17.6.1 RFFE search setup
Access: [Bus] > "Shortcuts" tab > "Setup search"
Type
The search criterion is defined by "T
ype". All trigger types are also available for search.
Additional search parameters are provided under "Detailed Search Parameter Setup".
For details, see also "Type" on page 761.
"Sequence Start"
Searches for SSC.
Additional search parameter: "Slave Addr.
" on page 773
"Sequence Stop"
Searches for bus park at the end of a command sequence.
Additional search parameter: "Slave Addr.
" on page 773
RFFE (option R&S RT
O6-K550)
To Next Page
Loading...
