R&S RTO6 - Page 773

Protocol analysis
R&S
®
RTO6
773User Manual 1801.6687.02 ─ 05
"Master Ownership Handover"
Searches for Master Ownership Handover command sequences.
Additional search parameters:
●
Address of the BOM-to-be, see "Slave Addr
."
on page 773
●
Data pattern of the confirmation sequence of the new BOM, see
"Data" on page 774.
"Interrupt Summary and Notification"
Searches for interrupts. Additional search parameters:
●
Slave address, see "Slave Addr
." on page 773
●
Byte count, see "Byte count" on page 773
●
Data of the interrupt identification sequence, see
"Error Condition"
Searches for the selected errors, see "Error conditions"
on page
774.
Remote command:
SEARch:TRIGger:RFFE:
TYPE on page 2076
Slave Addr.
Searches for a slave address or a slave address range.
In command sequences transferred between masters, this is the non-BOM address.
The slave address settings are the same as in the RFFE trigger setup, see "Slave
Addr. /MID " on page 766.
Remote command:
SEARch:TRIGger:RFFE:SADD:CONDition on page 2078
SEARch:TRIGger:RFFE:SADD:MIN on page 2080
SEARch:TRIGger:RFFE:SADD:MAX on page 2080
Byte count
Searches for a byte count or a byte count range.
The byte count settings are the same as in the RFFE trigger setup, see "Byte count"
on page 766
Remote command:
SEARch:TRIGger:RFFE:BCOunt:CONDition on page 2079
SEARch:TRIGger:RFFE:BCOunt:MIN on page 2080
SEARch:TRIGger:RFFE:BCOunt:MAX on page 2080
Address
Searches for a register address or an address range.
The register address settings are the same as in the RFFE trigger setup, see
"Address" on page 766.
Remote command:
SEARch:TRIGger:RFFE:ADDRess:CONDition on page 2078
SEARch:TRIGger:RFFE:ADDRess:MIN on page 2080
SEARch:TRIGger:RFFE:ADDRess:MAX on page 2080
RFFE (option R&S RT
O6-K550)