R&S RTO6 - Page 2079

Remote control commands
R&S
®
RTO6
2079User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:RFFE:BCOunt:CONDition <SearchName>,<ByteCntOperator>
SEARch:TRIGger:RFFE:BCOunt:CONDition? <SearchName>
SEARch:TRIGger:RFFE:DA
T
A:DCON <SearchName>,<DatPattOptor>
SEARch:TRIGger:RFFE:DATA:DCON? <SearchName>
Sets the operator to search for a specific pattern or a range
Parameters:
<DatPattOptor> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set using the corresponding SEARch:TRIG
ger:RFFE:...:MIN
command.
INRange | OORange
In range / Out of range: Set the minimum and maximum value
using the corresponding SEARch:TRIGger:RFFE:...:MIN
and SEARch:TRIGger:RFFE:...:MAX
*RST: EQUal
Parameters for setting and query:
<SearchName> String parameter
Example: See "Searching RFFE data" on page 1274
SEARch:TRIGger:RFFE:DATA:ICONdition <SearchName>,<DataIdxOperator>
SEARch:TRIGger:RFFE:DAT
A:ICONdition? <SearchName>
Sets the operator to define the data frames in which the data pattern is searched
Parameters:
<DataIdxOperator> EQUal | LTHan | LETHan | GTHan | GETHan | INRange |
RANGe
EQUal | LTHan | LETHan | GTHan | GETHan
Equal, Less than, Less or equal than, Greater Than, Greater or
equal than. These conditions require one pattern to be set using
SEARch:
TRIGger:RFFE:DATA:IMIN.
INRange = RANGe
In range: Set the minimum and maximum value using SEARch:
TRIGger:RFFE:DATA:IMIN and SEARch:TRIGger:RFFE:
DATA:IMAX.
*RST: INRange
Parameters for setting and query:
<SearchName> String parameter
Protocols