R&S RTO6 - 24.25 Maintenance

Remote control commands
R&S
®
RTO6
2570User Manual 1801.6687.02 ─ 05
24.25 Maintenance
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order
,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
T
o prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 24.3, "Programming examples", on page 1259
DIAGnostic:SERVice:WFAModel?..................................................................................2570
DIAGnostic:SERVice:WFASeries?................................................................................. 2570
DIAGnostic:SERVice:WFAType?....................................................................................2570
CALibration:DATE?...................................................................................................... 2571
CALibration:TIME?.......................................................................................................2571
CALibration:RESult?.....................................................................................................2571
DIAGnostic:SERVice:STST:EXECute............................................................................. 2571
DIAGnostic:SERVice:STST:STATe?............................................................................... 2571
DIAGnostic:SERVice:PWD............................................................................................2572
DIAGnostic:SERVice:WFAModel?
Returns the model name of the oscilloscope.
Return values:
<WFAModel> Product type
Usage: Query only
Asynchronous command
DIAGnostic:SERVice:WFASeries?
Returns the model series of the oscilloscope.
Return values:
<WFASeries> RTO | RTE | RTP
*RST: RTO
Usage: Query only
Asynchronous command
DIAGnostic:SERVice:WFAType?
Returns the instrument family of the oscilloscope.
Maintenance