R&S RTO6 - 11.2.2.2 Glitch; 11.2.2.3 Width

Search functions
R&S
®
RTO6
424User Manual 1801.6687.02 ─ 05
11.2.2.2 Glitch
The glitch search works the same way as the glitch trigger. To apply the trigger settings
to search, tap Copy from trigger A'.
The glitch search is not available if the search source is a digital channel.
Polarity, Range, Width
See trigger settings:
●
"Range"
on page 197
●
"Width" on page 197
●
"Polarity" on page 197
Remote command:
SEARch:TRIGger:GLITch:POLarity on page 1609
SEARch:TRIGger:GLITch:RANGe on page 1609
SEARch:TRIGger:GLITch:WIDTh on page 1609
Level
Sets the voltage level for trigger search. The value is used for all search event types
that require one trigger level. The search trigger level is search-specific, you can define
different levels in dif
ferent searches for the same event.
Remote command:
SEARch:TRIGger:LEVel[:VALue] on page 1607
11.2.2.3 Width
The width search works the same way as the width trigger. To apply the trigger settings
to search, tap Copy from trigger A'.
Search setup