Protocol analysis
R&S
®
RTO6
723User Manual 1801.6687.02 ─ 05
Remote commands
Remote commands to retrieve decode results are described in Chapter 24.17.15.3,
"Decode results", on page 2005
.
13.14.5
Search on decoded SpaceWire data
Using the search functionality, you can find various events in the decoded data. You
can find the same events that you can trigger on, and even many more, since several
event types can also be combined.
Before you can start the search, you have to configure the bus correctly and acquire
decoded data.
To search on decoded data, set the search source to "SerBus" for the configured proto-
col.
For general information on how to handle the search functionality, see Chapter 11,
"Search functions", on page 419.
13.14.5.1 SpaceWire search setup
Access: [Bus] > "Shortcuts" tab > "Setup search"
Type
Sets the search type for the SpaceWire analysis.
"Control frame"
Searches for the selected control type frame.
"Data Pattern"
Searches for a defined data pattern or pattern range.
"NULL frame"
Searches for a null frame, a frame without usable data.
"Time Code"
Searches for a time-code control code. You can define the data pat-
tern of the time code to be searched for.
"ERRORs"
Searches for an enabled error type.
Remote command:
SEARch:TRIGger:SWIRe:
TYPE on page 2014
Trigger Control Type
Searches for a specific control type character.
SpaceWire (option R&S RT
O6-K530)
To Next Page
Loading...
