R&S RTO6 - 19.3.2.3 Inrush current settings

Power analysis (option R&S RTO6-K31)
R&S
®
RT
O6
1144User Manual 1801.6687.02 ─ 05
7. Select the "Settings" tab.
8.
Set the "T
rigger current value".
9. Set the "Maximum current" that should be displayed in the vertical scale.
10. In the "Gate configuration" table, define the different time periods. You can set up
to five different gates.
11. Tap "Execute".
12. Start the DUT.
On the screen, you can see the result box with the inrush current of each gate. For
details, see Chapter 19.3.2.1, "Inrush current results", on page 1142.
19.3.2.3 Inrush current settings
In the "Channels" tab, you set the current source, see also: Chapter 19.2.1, "Channels
tab", on page 1134.
In the "Settings" tab, you configure the inrush current measurement parameters and
display settings.
Input