R&S RTO6 - 24.10.2.2 Scaling

Remote control commands
R&S
®
RTO6
1448User Manual 1801.6687.02 ─ 05
REFCurve<m>:UPDate
Copies the selected source waveform (see REFCurve<m>:
SOURce on page
1446)
with all its settings to the memory of the reference waveform.
Suffix:
<m>
.
1..4
Reference waveform
Usage: Event
REFCurve<m>:SAVE
Saves the reference waveform to the file selected by REFCurve<m>:NAME
on page
1447.
Suffix:
<m>
.
1..4
Reference waveform
Usage: Event
REFCurve<m>:DELete
Deletes the reference waveform file selected by REFCurve<m>:NAME
on page 1447.
Suffix:
<m>
.
1..4
Reference waveform
Usage: Event
REFCurve<m>:CLEar
The selected reference waveform is no longer displayed, its memory is deleted.
Suffix:
<m>
.
1..4
Reference waveform
Usage: Event
Asynchronous command
24.10.2.2 Scaling
REFCurve<m>:RESTore
...............................................................................................1449
REFCurve<m>:VMODe................................................................................................ 1449
REFCurve<m>:SCALe................................................................................................. 1449
REFCurve<m>:POSition...............................................................................................1450
REFCurve<m>:TOORignal............................................................................................1450
REFCurve<m>:RESCale:VERTical:STATe......................................................................1450
REFCurve<m>:RESCale:VERTical:FACTor.....................................................................1450
Waveform analysis