Protocol analysis
R&S
®
RTO6
618User Manual 1801.6687.02 ─ 05
Remote command:
SEARch:
TRIGger:LIN:
IDOR<m>:ENABle on page 1855
SEARch:TRIGger:LIN:IDOR<m>[:VALue] on page 1855
Error Condition
Selects the error type to be searched for. You can select one or more error types as
search condition.
The error types are the same as in the LIN trigger setup, see "Error conditions"
on page 614.
Remote command:
SEARch:TRIGger:LIN:IPERror on page 1858
SEARch:TRIGger:LIN:SYERror on page 1858
SEARch:TRIGger:LIN:CHKSerror on page 1858
SEARch:TRIGger:LIN:ERRPattern on page 1859
SEARch:TRIGger:LIN:CRCDatalen on page 1859
SEARch:TRIGger:LIN:STANdard on page 1859
13.8.5.2 LIN search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands are listed in Chapter 24.17.9.5, "LIN search results", on page 1859.
13.9 FlexRay (option R&S RTO6-K520)
FlexRay is designed for use in safety-related distributed applications in the automotive
industry
. It is applied in real-time applications when higher data rates and reliable com-
munication are required. In particular
, FlexRay supports x-by-wire applications, for
example, steer-by-wire or brake-by-wire.
13.9.1 FlexRay configuration
13.9.1.1 FlexRay configuration
Access: [Bus] > "Setup" tab > "Protocol" = FlexRay
FlexRay (option R&S RT
O6-K520)
To Next Page
Loading...
