R&S RTO6 - Page 1858

Remote control commands
R&S
®
RTO6
1858User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:LIN:DLENgth <SearchName>,<W
ordCount>
SEARch:TRIGger:LIN:DLENgth?
<SearchName>
Sets the length of the bit pattern to be found, in bytes.
For complete definition, set the operator using SEARch:TRIGger:LIN:
DLECondition, and the transfer direction with SEARch:TRIGger:LIN:BORDer.
Parameters:
<WordCount> Range: 1 to 8
Increment: 1
*RST: 1
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:IPERror <SearchName>,<IdParityError>
SEARch:TRIGger:LIN:IPERror? <SearchName>
Searches for errors in the identifier parity bits. These are the bits 6 and 7 of the identi-
fier.
Parameters:
<IdParityError>
ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:SYERror <SearchName>,<SyncError>
SEARch:TRIGger:LIN:SYERror? <SearchName>
Searches for synchronization errors.
Parameters:
<SyncError> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:CHKSerror <SearchName>,<ChecksumError>
SEARch:TRIGger:LIN:CHKSerror?
<SearchName>
Searches for checksum errors according to the LIN standard.
Use the following commands to configure the checksum error search:
●
SEARch:TRIGger:LIN:ERRPattern on page 1859
●
SEARch:TRIGger:LIN:CRCDatalen on page 1859
●
SEARch:TRIGger:LIN:STANdard on page 1859
Protocols