R&S RTO6 - 24.19.2 Pattern generator setup

Remote control commands
R&S
®
RTO6
2456User Manual 1801.6687.02 ─ 05
*RST: ARBitrary
WGENerator<m>:ARBGen:RUNSingle
Executes a single period of the arbitrary signal generator
, for WGENerator<m>:
ARBGen:
RUNModeSINGle.
Suffix:
<m>
.
1..2
Usage: Event
24.19.2 Pattern generator setup
PGENerator:BITRate....................................................................................................2456
PGENerator:ENABle
.................................................................................................... 2456
PGENerator:FILE:OPEN...............................................................................................2456
PGENerator:FILE[:NAME].............................................................................................2456
PGENerator:HLEVel.....................................................................................................2457
PGENerator:PRESet.................................................................................................... 2457
PGENerator:RUNMode.................................................................................................2457
PGENerator:RUNSingle................................................................................................2457
PGENerator:BITRate <BitRate>
Sets the number of transmitted bits per second for the pattern generator.
Parameters:
<BitRate> Range: 1 to 40E+6
Increment: 10
*RST: 1E+6
Default unit: bps
PGENerator:ENABle <State>
Enables the pattern generator and outputs the waveform.
Parameters:
<State> ON | OFF
PGENerator:FILE:OPEN
Loads the specified pattern file to the instrument.
Usage: Event
PGENerator:FILE[:NAME] <FilePath>
Specifies a file path to open a pattern generator file.
Waveform generator (option R&S RT
O6-B6)