R&S RTO6 - Page 2454

Remote control commands
R&S
®
RTO6
2454User Manual 1801.6687.02 ─ 05
Example: See WGENerator<m>:
ARBGen:
MULTichannel:IMPort
on page 2453.
Usage: Event
WGENerator<m>:ARBGen:NAME <FilePath>
Sets the file path and the file for an arbitrary waveform, if WGENerator<m>:ARBGen[:
SOURce]
on page 2455 is set to ARBitrary.
If not path is given, the default path
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\RefWaveforms
is used.
This command is only relevant for files with one waveform defined. For multichannel
arbitrary waveform files, see WGENerator<m>:ARBGen:MULTichannel:OPEN.
Suffix:
<m>
.
1..2
Parameters:
<FilePath>
WGENerator<m>:ARBGen:OPEN
Loads the arbitrary waveform, that is selected with the WGENerator<m>:
ARBGen:
NAME
command.
This command is only relevant for files with one waveform defined. For multichannel
arbitrary waveform files, see WGENerator<m>:ARBGen:MULTichannel:OPEN.
Suffix:
<m>
.
1..2
Usage: Event
WGENerator<m>:ARBGen:RUNMode <RunMode>
Sets the duration for which the signal of the arbitrary generator will be output after the
trigger event.
Suffix:
<m>
.
1..2
Parameters:
<RunMode> SINGle | CONTinuous
*RST: CONTinuous
WGENerator<m>:ARBGen:SAMPles?
Displays the number of samples for the arbitrary waveform.
Waveform generator (option R&S RT
O6-B6)