R&S RTO6 - 24.8.3 Acquisition

Remote control commands
R&S
®
RTO6
1332User Manual 1801.6687.02 ─ 05
24.8.3 Acquisition
ACQuire:INT
erpolate....................................................................................................
1332
ACQuire:CDTA............................................................................................................ 1332
ACQuire:MUWaveform................................................................................................. 1333
CHANnel<m>[:WAVeform<n>][:STATe]...........................................................................1333
CHANnel<m>[:WAVeform<n>]:TYPE..............................................................................1333
CHANnel<m>[:WAVeform<n>]:ARIThmetics................................................................... 1334
ACQuire:COUNt.......................................................................................................... 1334
ACQuire:ARESet:IMMediate......................................................................................... 1335
ACQuire:ARESet:MODE...............................................................................................1335
ACQuire:ARESet:TIME.................................................................................................1335
ACQuire:ARESet:COUNt.............................................................................................. 1335
ACQuire:INTerpolate <IntpolMd>
Selects the interpolation method.
See also: "Interpolation" on page 128.
Parameters:
<IntpolMd> LINear | SINX | SMHD
LINear
Linear interpolation between two adjacent sample points
SINX
Interpolation by means of a sin(x)/x curve.
SMHD
Sample/Hold causes a histogram-like interpolation.
*RST: SINX
Usage: Asynchronous command
ACQuire:CDTA <CoupleAcquSet>
Sets the acquisition mode and the waveform arithmetic of all channels to the last set
value.
If the acquisition settings are coupled, ACQuire:
MUWaveform is not relevant, only
one waveform per channel can be used.
Parameters:
<CoupleAcquSet>
ON | OFF
*RST: ON
Usage: Asynchronous command
Firmware/software: FW 3.30
Substitutes ACQuire:CMODode
Acquisition and setup