Remote control commands
R&S
®
RTO6
1319User Manual 1801.6687.02 ─ 05
Parameters:
<ClrMatchedMskBorder>Decimal value corresponding to the ARGB hex value that is
shown in the
"Color" dialog box. ARGB is a 32-bit unsigned inte-
ger with alpha, red, green, blue word order
. Alpha defines the
transparency.
To get the value, covert the hex value from the dialog to decimal
value.
Range: 0 (black) to 4294967295 (white)
Increment: 1
*RST: 2580309606
Usage: Asynchronous command
MTESt:COLor:INTerior <ClrMatchedMskInterior>
Sets the color of mask segments the signal has entered into.
Parameters:
<ClrMatchedMskInterior>Decimal value corresponding to the ARGB hex value that is
shown in the
"Color" dialog box. ARGB is a 32-bit unsigned inte-
ger with alpha, red, green, blue word order
. Alpha defines the
transparency.
To get the value, covert the hex value from the dialog to decimal
value.
Range: 0 (black) to 4294967295 (white)
Increment: 1
*RST: 2578055168
Usage: Asynchronous command
24.7.3 Display
24.7.3.1 Persistence
DISPlay:PERSistence[:ST
ATe].......................................................................................1319
DISPlay:PERSistence:INFinite.......................................................................................1320
DISPlay:PERSistence:TIME..........................................................................................1320
DISPlay:PERSistence:RESet........................................................................................ 1320
DISPlay:PERSistence[:STATe] <State>
If enabled, each new data point in the diagram area remains on the screen for the
duration defined using DISPlay:PERSistence:TIME, or as long as DISPlay:
PERSistence:INFinite is enabled.
If disabled, the signal value is only displayed as long as it actually occurs.
Instrument setup
To Next Page
Loading...
