Remote control commands
R&S
®
RTO6
2005User Manual 1801.6687.02 ─ 05
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:
SWIRe:TIME:
MIN and
TRIGger<m>:SWIRe:TIME:MAX.
*RST: EQUal
TRIGger<m>:SWIRe:TIME:MAX <TimePatternMax>
Sets the the end value of a data value for the time code range if TRIGger<m>:
SWIRe:
TIME:CONDition is set to INRange or OORange.
Suffix:
<m>
.
1..3
Parameters:
<TimePatternMax>
TRIGger<m>:SWIRe:TIME:MIN <TimePatternMin>
Specifies a pattern for the data value for the time code, or sets the the start value of a
pattern range.
Suffix:
<m>
.
1..3
Parameters:
<T
imePatternMin>
TRIGger<m>:SWIRe:TYPE <Type>
Sets the trigger type for the SpaceWire analysis.
Suffix:
<m>
.
1..3
Parameters:
<T
ype> CTRL | DATA | NULL | TIME | ERRor
*RST: CTRL
24.17.15.3 Decode results
BUS<m>:SWIRe:RESults:FCOunt................................................................................. 2006
BUS<m>:SWIRe:RESults:FRAMe<n>:DA
TA?................................................................. 2006
BUS<m>:SWIRe:RESults:FRAMe<n>:STARt?................................................................2006
BUS<m>:SWIRe:RESults:FRAMe<n>:STATe?................................................................2007
BUS<m>:SWIRe:RESults:FRAMe<n>:STOP?................................................................ 2007
BUS<m>:SWIRe:RESults:FRAMe<n>:TYPE?.................................................................2007
BUS<m>:SWIRe:RESults:FRAMe<n>:FLD<o>:FVAL?.....................................................2008
BUS<m>:SWIRe:RESults:FRAMe<n>:FLD<o>:STARt?................................................... 2008
BUS<m>:SWIRe:RESults:FRAMe<n>:FLD<o>:STATus?................................................. 2009
Protocols
To Next Page
Loading...
