R&S RTO6 - Page 2004

Remote control commands
R&S
®
RTO6
2004User Manual 1801.6687.02 ─ 05
Parameters:
<DataPatternMax>
TRIGger<m>:SWIRe:DATA:MIN <DataPatternMin>
Specifies a data for the data pattern, or sets the the start value of a pattern range.
Suffix:
<m>
.
1..3
Parameters:
<DataPatternMin>
TRIGger<m>:SWIRe:ERRor:ESC <ErrorESC>
Enables searching for an escape error.
Suffix:
<m>
.
1..3
Parameters:
<ErrorESC> ON | OFF
*RST: ON
TRIGger<m>:SWIRe:ERRor:PARity <ErrorParity>
Enables triggering on a parity error (even parity).
Suffix:
<m>
.
1..3
Parameters:
<ErrorParity> ON | OFF
*RST: ON
TRIGger<m>:SWIRe:TIME:CONDition <TimeOperator>
Set the condition for the data value for the time code. Y
ou can define an exact value or
a value range.
Suffix:
<m>
.
1..3
Parameters:
<TimeOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | L
THan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:
SWIRe:TIME:
MIN command.
Protocols