Remote control commands
R&S
®
RTO6
2436User Manual 1801.6687.02 ─ 05
*RST: HIGH
Usage: Asynchronous command
TRIGger<m>:PARallel:TIMeout:TIME <T
ime>
Defines the time limit for the timeout at which the instrument triggers.
Parameters:
<T
ime> Range: 100E-12 to 10000
Increment: 100E-9
*RST: 100E-9
Default unit: s
Usage: Asynchronous command
24.18.4.5 Setup & Hold trigger
See also:
●
TRIGger<m>:PARallel:
SETHold:CSOurce[:VALue] on page 2433
TRIGger<m>:PARallel:SETHold:CSOurce:EDGE............................................................ 2436
TRIGger<m>:PARallel:SETHold:HTIMe..........................................................................2436
TRIGger<m>:PARallel:SETHold:STIMe..........................................................................2437
TRIGger<m>:PARallel:SETHold:CSOurce:EDGE <ClockEdge>
Sets the edge of the clock signal. The crossing of the clock edge and the logical
threshold defines the time reference point for the setup and hold time measurement.
Parameters:
<ClockEdge> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
TRIGger<m>:PARallel:SETHold:HTIMe <HoldTime>
Sets the minimum time
after the clock edge while data should be stable and not
change its state.
See also: "Hold time" on page 1003
Parameters:
<HoldTime> Range: -99.8E-9 to 100E-9
Increment: 1E-9
*RST: 0
Default unit: s
Usage: Asynchronous command
Mixed signal option (MSO, R&S RT
O6-B1)
To Next Page
Loading...
