R&S RTO6 - 13.9.4.2 FlexRay search results; 13.10 SENT (option R&S RTO6-K520)

Protocol analysis
R&S
®
RTO6
634User Manual 1801.6687.02 ─ 05
Remote command:
SEARch:
TRIGger:FLXRay:
BSSerror on page 1892
SEARch:TRIGger:FLXRay:FESerror on page 1892
SEARch:TRIGger:FLXRay:FSSerror on page 1893
SEARch:TRIGger:FLXRay:HCRCerror on page 1893
SEARch:TRIGger:FLXRay:PCRCerror on page 1893
13.9.4.2 FlexRay search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands:
●
SEARch:RESult:FLXRay:FCOunt? on page 1894
●
SEARch:RESult:FLXRay:FRAMe<m>:ADID? on page 1894
●
SEARch:RESult:FLXRay:FRAMe<m>:CSSTate? on page 1894
●
SEARch:RESult:FLXRay:FRAMe<m>:CSValue? on page 1895
●
SEARch:RESult:FLXRay:FRAMe<m>:CYCount? on page 1895
●
SEARch:RESult:FLXRay:FRAMe<m>:DATA? on page 1895
●
SEARch:RESult:FLXRay:FRAMe<m>:FCSTate? on page 1896
●
SEARch:RESult:FLXRay:FRAMe<m>:FCValue? on page 1896
●
SEARch:RESult:FLXRay:FRAMe<m>:FLAGs? on page 1896
●
SEARch:RESult:FLXRay:FRAMe<m>:PAYLength? on page 1897
●
SEARch:RESult:FLXRay:FRAMe<m>:STATus? on page 1897
●
SEARch:RESult:FLXRay:FRAMe<m>:STARt? on page 1898
●
SEARch:RESult:FLXRay:FRAMe<m>:STOP? on page 1898
●
SEARch:RESult:FLXRay:FRAMe<m>:SYMBol? on page 1898
●
SEARch:RESult:FLXRay:FRAMe<m>:TYPE? on page 1898
13.10 SENT (option R&S RTO6-K520)
Single Ended Nibble Transmission (SENT) is a serial transmission interface protocol
originally specified for the communication of sensors and control units in automotive
electronics.
SENT (option R&S R
T
O6-K520)