Protocol analysis
R&S
®
RTO6
712User Manual 1801.6687.02 ─ 05
See also Chapter 1
1, "Search functions",
on page 419.
13.13.5.1 ARINC 429 search setup
Access: [Bus] > "Shortcuts" tab > "Setup search"
Type
The search criterion is defined by "T
ype". All trigger types are also available for search.
Additional search parameters are provided under "Detailed Search Parameter Setup".
"Word Start"
Searches for the start word.
"Word Stop"
Searches for the stop word.
"Label + Data"
Searches for a defined word format. You can search for the label, the
data, the SDI, and SSM bits separately.
For details, see
"Label + Data" on page 708.
"Error condition"
Identifies various errors in the frame, see "Error Conditions"
on page
709.
Remote command:
SEARch:TRIGger:ARINc:
TYPE on page 1993
Label setup: Condition, Label min, Label max
The label setup consists of the condition and one or two label patterns.
The label setup settings are the same as in the ARINC trigger setup, see "Label setup:
Condition, Label Min, Label Max" on page 708.
Remote command:
SEARch:TRIGger:ARINc:LABel:CONDition on page 1994
SEARch:TRIGger:ARINc:LABel:MIN on page 1994
SEARch:TRIGger:ARINc:LABel:MAX on page 1994
Data setup: Condition, Data min, Data max
The data setup consists of the condition and one or two data patterns.
The data setup settings are the same as in the ARINC trigger setup, see "Data setup:
Condition, Data Min, Data Max" on page 709.
ARINC 429 (option R&S RT
O6-K530)
To Next Page
Loading...
