R&S RTO6 User Manual

Search functions
R&S
®
RTO6
422User Manual 1801.6687.02 ─ 05
Depending on the selected source, different search criteria are available.
Remote command:
SEARch:
SOURce
on page 1605
Edge, Glitch, Width, Runt, Window, Timeout, Interval, Slew rate, Setup & Hold,
State, Pattern
Search criteria for analog and digital input signals, math and reference waveforms, and
tracks. For searching on digital channels, only "Edge", "Width", "Timeout" and "Setup &
Hold" criteria are available.
Tap the icon to include or exclude the search criteria in the next search. You can
enable several event types for simultaneous search.
Remote command:
SEARch:TRIGger:EDGE[:STATe] on page 1606
SEARch:TRIGger:GLITch[:STATe] on page 1606
SEARch:TRIGger:WIDTh[:STATe] on page 1607
SEARch:TRIGger:RUNT[:STATe] on page 1606
SEARch:TRIGger:WINDow[:STATe] on page 1607
SEARch:TRIGger:TIMeout[:STATe] on page 1607
SEARch:TRIGger:INTerval[:STATe] on page 1606
SEARch:TRIGger:SLEWrate[:STATe] on page 1607
SEARch:TRIGger:SETHold[:STATe] on page 1606
SEARch:TRIGger:STATe[:STATe] on page 1607
SEARch:TRIGger:PATTern[:STATe] on page 1606
Copy from trigger A'
Copies the trigger type-specific settings from the A-trigger configuration to the search
settings. The source itself is not copied.
Remote command:
SEARch:
TRIGger:EDGE:
ACOPy on page 1607
SEARch:TRIGger:GLITch:ACOPy on page 1607
SEARch:TRIGger:WINDow:ACOPy on page 1608
SEARch:TRIGger:WIDTh:ACOPy on page 1608
SEARch:TRIGger:RUNT:ACOPy on page 1607
SEARch:TRIGger:WINDow:ACOPy on page 1608
SEARch:TRIGger:TIMeout:ACOPy on page 1608
SEARch:TRIGger:INTerval:ACOPy on page 1607
SEARch:TRIGger:SLEWrate:ACOPy on page 1607
SEARch:TRIGger:SETHold:ACOPy on page 1607
SEARch:TRIGger:STATe:ACOPy on page 1608
SEARch:TRIGger:PATTern:ACOPy on page 1607
11.2.2 Search parameters
Most parameters available for trigger event definition can also be configured as search
conditions. Each event type is defined in a separate subtab.
If the source is a spectrum, the instrument performs a frequency marker search.
Search setup

R&S RTO6 Specifications

General

Bandwidth	Up to 6 GHz
Sample Rate	Up to 20 Gsample/s
Memory Depth	Up to 2 Gsample
Channels	Up to 4
Vertical Sensitivity	1 mV/div to 10 V/div
Vertical Resolution	Up to 16 bit
Trigger Modes	Edge, Pulse
Interface	LAN, USB, GPIB
Input Impedance	50 Ω, 1 MΩ