Data and file management
R&S
®
RTO6
467User Manual 1801.6687.02 ─ 05
The histograms settings are defined in the "Histogram" dialog box ("Menu" > "Apps" >
"Analysis"
tab > "Histogram").
See also: Chapter 8.2.8.4, "Histogram setup", on page 345.
Select
Selects the histogram to be exported. All active waveform histograms are shown in the
list.
Measurement histograms can also be exported, see Chapter 12.2.5, "Result plots
analysis", on page 469.
Remote command:
EXPort:HISTogram:SELect on page 1656
Source
Displays the source of the selected histogram.
Incidence
Sets the mode of exported histogram data: relative or absolute count of values. If rela-
tive values are exported, the sum of all values is 1, and the count of each value is set
in relation to the sum.
Remote command:
EXPort:HISTogram:INCidence on page 1656
Horizontal range, Vertical range
Displays the "Start" and "Stop" limits of the histogram area.
Save to file
Enter the filename to save the waveform histogram to. Double-tap the filename to open
the file selection dialog box.
By default, the filename has the prefix "Histogram_". You can define a pattern for auto-
matic naming in the "Autonaming" tab. The default directory is:
C:\Users\Public\Documents\Rohde-Schwarz\RTO6\Histograms
"Save"
Saves the histogram data in the selected file.
"Save As..."
Opens the file selection dialog box and saves the histogram data to
the selected file. See also Chapter 12.5, "File selection dialog",
on page
482
".bin/.xml/.csv"
Selects the file format.
Remote command:
EXPort:HISTogram:
NAME on page 1657
EXPort:HISTogram:SAVE on page 1657
EXPort:HISTogram:DATA? on page 1657
12.2.4 Results
In this dialog, you can select the result boxes to be saved, and define the storage set-
tings.
Save and recall waveform data and results
To Next Page
Loading...
