Data and file management
R&S
®
RTO6
468User Manual 1801.6687.02 ─ 05
Access: "Menu" key >"Save/Recall" key > "Save" tab > "Results"
Access to the tab is available in all tabs where measurement and analysis settings are
defined, for example, in the
"Measurements Setup"
, "Cursors Setup", and "Masks Test
Definition" tabs: Simply tap the "Export" button.
Furthermore, you can export the decode result tables of serial protocol analysis.
Result selection
The table lists all result boxes and decode tables that are currently open, including
minimized boxes and docked boxes. Select the results that you want to save to file. All
results are written into one file.
Note: If the result box is minimized, only the columns shown on the result icon are
saved (2 columns). Statistical results are not shown on the minimized results icon, and
they are not saved.
Numeric values in decimal and without unit
By default, numeric result values are written with their unit to the file. If the option is
enabled, the values are saved with more decimal places.
Export results
Enter the filename to save the results to. Double-tap the filename to open the file
selection dialog box.
By default, the filename has the prefix
"ResultBoxExport_"
.
Save and recall waveform data and results
To Next Page
Loading...
