R&S RTO6 - 24.17.22.2 Digital signal processing (DSP)

Remote control commands
R&S
®
RTO6
2190User Manual 1801.6687.02 ─ 05
Parameters:
<Protocol> SS
*RST: SS
Usage: Asynchronous command
24.17.22.2 Digital signal processing (DSP)
BUS<m>:CTLE:DCGain................................................................................................2190
BUS<m>:CTLE:ENBLe.................................................................................................2190
BUS<m>:CTLE:P1FReq
............................................................................................... 2190
BUS<m>:CTLE:P2FReq............................................................................................... 2191
BUS<m>:CTLE:Z1FReq............................................................................................... 2191
BUS<m>:USBThree:BITR.............................................................................................2191
BUS<m>:USBThree:DFE:COEFficient........................................................................... 2191
BUS<m>:USBThree:DFE:ENBLe...................................................................................2192
BUS<m>:USBThree:DFE:ESTCoeff...............................................................................2192
BUS<m>:USBThree:DFE:TCONt...................................................................................2192
BUS<m>:USBThree:PROTocol......................................................................................2192
BUS<m>:CTLE:DCGain <DCGain>
Sets the adjustable DC gain. This value can be chosen according to the channel loss
characteristics. For low-loss channels, you can set a value close to 0 dB.
Suffix:
<m>
.
1..4
Parameters:
<DCGain> Range: -100 to 100
Increment: 0.01
*RST: 0
Default unit: dB
BUS<m>:CTLE:ENBLe <EnableCTLE>
Enables the continuous time linear equalization (CTLE) equalization.
Suffix:
<m>
.
1..4
Parameters:
<EnableCTLE> ON | OFF
*RST: OFF
BUS<m>:CTLE:P1FReq <PoleOneFreq>
Sets the pole 1 frequency for the transfer function of the CTLE algorithm.
Suffix:
<m>
.
1..4
Protocols