Remote control commands
R&S
®
RTO6
1561User Manual 1801.6687.02 ─ 05
24.12.15.4 Hysteresis
REFLevel<m>:RELative:
HYST
eresis <Value>
Defines a hysteresis for the middle reference level. A rise or fall from the middle refer-
ence value that does not exceed the hysteresis is rejected as noise.
Suffix:
<m>
.
Valid suf
fix numbers: 2 to 21, 61 to 68, 108 to 118, 151 to 157,
173 to 179
Source waveform of the measurement, see Chapter 24.4.1,
"Waveform suffix", on page 1279.
Parameters:
<Value>
Usage: Asynchronous command
24.12.15.5 Tube
REFLevel<m>:RELative:
OTUBe....................................................................................1561
REFLevel<m>:RELative:ITUBe..................................................................................... 1561
REFLevel<m>:ABSolute:TOTube...................................................................................1562
REFLevel<m>:ABSolute:TITube.................................................................................... 1562
REFLevel<m>:ABSolute:BITube....................................................................................1562
REFLevel<m>:ABSolute:BOTube.................................................................................. 1563
REFLevel<m>:RELative:OTUBe <Value>
Defines a percentage of the signal level by which the absolute signal level may be
larger than the high signal level or lower than the low signal level to be considered high
or low, respectively.
Suffix:
<m>
.
V
alid suf
fix numbers: 2 to 21, 61 to 68, 108 to 118, 151 to 157,
173 to 179
Source waveform of the measurement, see Chapter 24.4.1,
"Waveform suffix", on page 1279.
Parameters:
<Value>
Usage: Asynchronous command
REFLevel<m>:RELative:ITUBe <Value>
Defines a percentage of the signal level by which the absolute signal level may be
higher than the low signal level or lower than the high signal level to be considered low
or high, respectively
.
Automatic measurements
To Next Page
Loading...
