R&S RTO6 - 13.26.2.2 Display settings

Protocol analysis
R&S
®
RTO6
939User Manual 1801.6687.02 ─ 05
Couple thresholds ← Thresholds
Enables the same threshold value for all lanes.
Find thresholds
← Thresholds
Executes the measurement of reference levels and sets the thresholds to the middle
reference level of the measured amplitude.
Remote command:
BUS<m>:
SETReflevels on page 1671
Low threshold ← Thresholds
Sets the lower threshold value for the respective lane.
Remote command:
BUS<m>:PCIE:LONE:THRLow on page 2349
BUS<m>:PCIE:LTHRee:THRLow on page 2349
BUS<m>:PCIE:LTWO:THRLow on page 2349
BUS<m>:PCIE:LZER:THRLow on page 2349
High threshold ← Thresholds
Sets the high threshold value for the respective lane.
Remote command:
BUS<m>:PCIE:LONE:THRHigh on page 2348
BUS<m>:PCIE:LTHRee:THRHigh on page 2348
BUS<m>:PCIE:LTWO:THRHigh on page 2348
BUS<m>:PCIE:LZER:THRHigh on page 2348
13.26.2.2 Display settings
Access: [Bus] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 487.
PCIe (option R&S RT
O6-K72)