R&S RTO6 - 24.9.22 External trigger input

Remote control commands
R&S
®
RTO6
1434User Manual 1801.6687.02 ─ 05
Usage: Asynchronous command
24.9.22 External trigger input
External trigger signals, which are connected to the external trigger input, can be trig-
gered with an edge trigger
.
TRIGger<m>:ANEDge:COUPling <Coupling>
Sets the coupling for the external trigger signal.
Suffix:
<m>
.
1..3
Only 1 = A-trigger
, 2 | 3 = not available. Can be omitted.
Parameters:
<Coupling>
DC | DCLimit | AC
DC
Direct connection with 50 Ω termination, passes both DC and
AC components of the trigger signal.
DCLimit
Direct connection with 1 MΩ termination, passes both DC and
AC components of the trigger signal.
AC
Connection through DC capacitor, removes DC and very low-fre-
quency components.
Usage: Asynchronous command
TRIGger<m>:ANEDge:FILTer <Filter>
Sets a filter for the external trigger signal to reject high or low frequencies.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<Filter> OFF |
LFReject | RFReject
OFF
The trigger signal is not filtered.
LFReject
Frequencies higher than the "Cut-of
f" frequency are rejected,
lower frequencies pass the filter.
You can adjust the "Cut-off" frequency using the TRIGger<m>:
ANEDge:CUToff:LOWPass command, the default is 50 kHz.
Trigger