R&S RTO6 - Page 770

Protocol analysis
R&S
®
RTO6
770User Manual 1801.6687.02 ─ 05
Decode Results Table
The results are shown in two tables:
●
"Decode results"
: contains information about all decoded frames
●
"Details frame": contains more detailed information about the selected frame in the
"Decode results"
table.
Table 13-26: Content of the Decode results table
Column Description
State Overall state of the frame.
"Insuffcient waveform length"
indicates that the frame is not completely contained
in the acquisition. Change the horizontal scale, or move the reference point to the
left to get a longer acquisition.
Start Time of command sequence start (SSC)
Type Type of the command sequence
SA /MID Address of the SA/ MID
BC Byte count (decimal value)
Address Register address (hex value)
Label Symbolic name of the address if a label list is applied.
Table 13-27: Content of the Details frame table
Column Description
Parity control Checks if there an error in the parity
Parity address 0/1 Checks if there an error in the parity address
Read bit rate Value of the read bit rate
Write bit rate Value of the write bit rate
Name Type of the command sequence
State Overall state of the frame.
"Insuffcient waveform length"
indicates that the frame is not completely contained
in the acquisition. Change the horizontal scale, or move the reference point to the
left to get a longer acquisition.
Value Values of the data bytes.
Tools
Press "Display settings" in the "Decode Results"
table to access the "Display" tab.
RFFE (option R&S RT
O6-K550)