R&S RTO6 - Page 2163

Remote control commands
R&S
®
RTO6
2163User Manual 1801.6687.02 ─ 05
BUS<m>:USB:PACKet<n>:PORT?................................................................................
2166
BUS<m>:USB:
PACKet<n>:SC?.....................................................................................2166
BUS<m>:USB:PACKet<n>:SEU?.................................................................................. 2166
BUS<m>:USB:PACKet<n>:STARt?................................................................................2167
BUS<m>:USB:PACKet<n>:STATus?..............................................................................2167
BUS<m>:USB:PACKet<n>:STOP?................................................................................ 2167
BUS<m>:USB:PCOunt?............................................................................................... 2168
BUS<m>:USB:PACKet<n>:PID?
Returns the packet PID for the selected serial bus and packet number.
Suffix:
<m>
.
1..4
<n> *
Return values:
<PID> RES | OUT | ACK | DATA0 | DATa0 | PING | SOF | NYET |
DA
T
A2 | DATa2 | SPLIT | SPLit | IN | NAK | DATA1 | DATa1 |
PRE | SETUP | SETup | STALL | STALl | MDATA | MDATa | UNK
RES
RES = Reserved
OUT
OUT Token PID
IN
IN Token PID
SOF
Start Of Frame PID
SETUP = SETup
SETUP PID
DATA0 = DATa0
DATA0 PID, even PID
DATA1 = DATa1
DATA1 PID, odd PID
DATA2 = DATa2
DATA2 PID (only valid in USB high speed and USB HSIC proto-
cols)
MDATA = MDATa
MDATA PID (only valid in USB high speed and USB HSIC proto-
cols)
ACK
ACKnowledgment PID
NAK
Non-AcKnowledgment PID
STALL = STALl
STALL PID
Protocols