R&S RTO6 - Page 977

Protocol analysis
R&S
®
RTO6
977User Manual 1801.6687.02 ─ 05
Remote command:
EYE<m>:
TIMReference:
CLOCk:LEVel on page 2406
Clock frequency ← Explicit clock
Sets the clock frequency of the explicit clock signal. If this value is unknown, you can
use "Estimate clock frequency".
Remote command:
EYE<m>:TIMReference:CLOCk:FREQuency on page 2405
Estimate clock frequency ← Explicit clock
Calculates an estimate value for the clock frequency.
Remote command:
EYE<m>:TIMReference:CLOCk:FREStimation on page 2406
Clock multiplier ← Explicit clock
Sets a value for the clock multiplier, the ratio of an internal clock rate to the externally
supplied clock.
Remote command:
EYE<m>:TIMReference:CLOCk:FACTor on page 2405
Clock edge ← Explicit clock
The clock edge sets the point in time when the state of the data signal is checked:
"Positive"
Rising edge, a positive voltage change.
"Negative"
Falling edge, a negative voltage change.
"Either"
Both the rising and the falling edge.
Remote command:
EYE<m>:
TIMReference:
CLOCk:EDGE on page 2405
Data rate ← Explicit clock
Displays the calculated data rate. It is calculated as follows:
"Data rate" = "Clock frequency" * "Clock multiplier"*X
Where X is:
●
1 for "Clock edge"= "Positive" or "Negative"
●
2 for "Clock edge"= "Either"
Remote command:
ADVJitter<m>:SIGNal:DATRate? on page 2488
Clock offset ← Explicit clock
Sets a clock offset. If this value is unknown, you can use "Estimate clock offset".
Remote command:
EYE<m>:TIMReference:CLOCk:OFFSet on page 2406
Estimate clock offset ← Explicit clock
Calculates an estimate value for the clock offset.
DDR (option R&S RT
O6-K91 )