R&S RTO6 - Page 1948

Remote control commands
R&S
®
RTO6
1948User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:CXPI:DEXTension:CONDition
<SearchName>,<DLCEXT
Operator>
SEARch:TRIGger:CXPI:DEXT
ension:CONDition? <SearchName>
Set the condition for the DLC extend value. You can define an exact value or a value
range.
Parameters:
<DLCEXTOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:
TRIGger:CXPI:
DEXTension:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:CXPI:DEXTension:MIN
and SEARch:TRIGger:CXPI:DEXTension:MAX.
*RST: EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DEXTension:MAX <SearchName>,<DLCEXTMax>
SEARch:TRIGger:CXPI:DEXTension:MAX? <SearchName>
Sets the end value of a DLC extend range if SEARch:
TRIGger:CXPI:DEXTension:
CONDition is set to INRange or OORange.
Parameters:
<DLCEXTMax>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DEXTension:MIN <SearchName>,<DLCEXTMin>
SEARch:TRIGger:CXPI:DEXTension:MIN? <SearchName>
Specifies a data extension bit pattern, or sets the start value of a pattern range.
Parameters:
<DLCEXTMin>
Parameters for setting and query:
<SearchName>
Protocols