R&S RTO6 - Page 1931

Remote control commands
R&S
®
RTO6
1931User Manual 1801.6687.02 ─ 05
BUS<m>:CXPI:DORD <DisplayOrder>
Selects the order in which the signal is displayed in the honeycomb.
If TRANsmitted
is selected, the signal is displayed in the order it occurs. If LOGical
is selected, the signal is displayed according to the definition of the standard (MSB bit
order).
Suffix:
<m>
.
1..4
Parameters:
<DisplayOrder>
TRANsmitted | LOGical
*RST: TRANsmitted
BUS<m>:CXPI:HYSTeresis <ThresHyst>
Sets a value for the hysteresis.
Suffix:
<m>
.
1..4
Parameters:
<ThresHyst> Range: -12 to 12
Increment: 0.01
*RST: 1
Default unit: V
BUS<m>:CXPI:POLarity <Polarity>
Sets the polarity of the transmitted waveform to normal (high = 1) or inverted (low = 1).
Suffix:
<m>
.
1..4
Parameters:
<Polarity> NORMal | INVert
*RST: NORMal
BUS<m>:CXPI:THReshold <Threshold>
Sets the threshold value for the signal.
Suffix:
<m>
.
1..4
Parameters:
<Threshold> Range: -15 to 12
Increment: 0.01
*RST: 6
Default unit: V
Protocols