R&S RTO6 - Page 1312

Remote control commands
R&S
®
RTO6
1312User Manual 1801.6687.02 ─ 05
Usage: Asynchronous command
DISPlay:SIGNal:LABel:TEXT <LabelID>, <Source>, <LabelT
ext>
DISPlay:SIGNal:LABel:TEXT? <LabelID>, <Source>
Modifies or queries the text of the specified label.
Parameters:
<LabelT
ext> String with the label text that is shown
Parameters for setting and query:
<LabelID> String with the label identifier.
<Source> All waveforms that can be displayed, see DISPlay:
SIGNal:
LABel:
ADD
Usage: Asynchronous command
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition <LabelID>, <Source>,
<Position>
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition?
<LabelID>, <Source>
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition <LabelID>, <Source>,
<Position>
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition? <LabelID>, <Source>
Modifies or queries the absolute horizontal and vertical positiions of the specified label
if DISPlay:SIGNal:LABel:POSMode is set to ABS.
Parameters:
<Position> Range: Depends on waveform position and scaling
Default unit: s and V, or in other units depending on the wave-
form character
Parameters for setting and query:
<LabelID> String with the label identifier.
<Source> All waveforms that can be displayed, see DISPlay:
SIGNal:
LABel:
ADD
Example:
:DISPlay:SIGNal:LABel:POSMode C2W1, ABS
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition 'Label1', C2W1, 5e-09
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition 'Label1', C2W1, -0.1
Move the label to 5 ns and -0.1 V
.
Instrument setup