Getting started
R&S
®
RTO6
57User Manual 1801.6687.02 ─ 05
Tap the diagram where you want to set the cursors, or draw a rectangle in the diagram
to position the cursor lines. The resulting cursor lines measure the selected waveform,
and the results are shown.
Mask Test
Starts the on-screen mask definition and the testing against the defined mask.
Tap the icon and then tap the points that build the mask. T
o finish the shape definition,
tap "Finish segment" in the overlay menu. To create a rectangular mask, draw a rect-
angle on the screen. You can add more segments to the test, and add another test.
You can also move the mask segments on the screen.
To configure the mask test settings, tap the
icon in the "Mask" result box.
Histogram
Creates a histogram. Tapping the icon opens the overlay menu, where you select the
histogram type and source.
Drag a rectangle on the diagram to define the histogram area. The histogram for the
selected waveform appears.
T
o change settings, touch and hold the histogram area, and the histogram overlay
menu opens.
Measure
Performs automatic measurements. T
apping the icon opens the overlay menu, where
you select the category
, the measurement types and measured waveform. Tap the dia-
gram with the waveform to be measured. To define a measurement gate, draw a rect-
angle on the screen.
You can run up to 8 automatic measurement groups in parallel. The "Measure" icon
starts the measurement groups one after the other. A measurement group consists of
minimum one measurement, and can consist of many measurements of the same cat-
egory.
To modify the measurement, double-tap one of the result values.
Quick meas
Performs a set of measurements on the selected waveform or on the selected gate.
Y
ou can configure up to 8 measurements to be included in quick measurement.
T
ap the icon and then tap the waveform to be measured or draw a rectangle to define
the gate.
FFT
Transforms a waveform to the frequency spectrum by fast Fourier transform (FFT). The
FFT trace is shown in a new diagram.
T
ap the icon and adjust the settings in the overlay menu. Select the source of the spec-
trum in the overlay menu. The FFT diagram is created from the selected waveform.
To adjust FFT settings, double-tap the FFT diagram.
Operating the instrument
To Next Page
Loading...
