R&S RTO6 - Page 56

Getting started
R&S
®
RTO6
56User Manual 1801.6687.02 ─ 05
Find Level
Analyses the signal and sets the trigger level to the middle of the signal peaks.
Force T
rigger
Starts an immediate single acquisition. If the acquisition is running in normal mode and
no valid trigger occurs, use
"Force Trigger" to confirm that a signal is available. Then
you can use the displayed waveform to determine how to trigger on it.
Demo
Opens the "Demo"
dialog, where you can find examples of operating the R&S RTO6.
Zoom
Creates a zoom. Tapping the icon opens the overlay menu, where you select one of
the four zoom types: standard zoom, hardware zoom, coupled zoom, fingertip zoom.
Standard zoom ← Zoom
Displays a magnified section of the diagram in an additional zoom diagram. It is a dis-
play zoom, instrument settings are not changed.
Touch and hold the zoom area to open the
"Zoom" dialog box.
Remote command:
LAYout:ZOOM:ADD on page 1438
Hardware zoom ← Zoom
Changes the instrument settings - horizontal and vertical scales as well as trigger level
and offset - to display a part of the diagram in greater detail.
Coupled zoom
← Zoom
Creates a coupled zoom area and its related zoom diagram. If you change the size of
one zoom area, the size of all coupled zoom areas is changed as well.
Remote command:
LAYout:ZOOM:ADDCoupled
on page 1438
Fingertip zoom ← Zoom
Magnifies the waveforms around your fingertip.
Tap the icon and put your finger on the waveform. The touched part of the waveform is
displayed in a magnifier. Drag your finger on the screen to move the magnifier. You can
change the zoom factor using the [Multiuse] knob.
Search
Performs a search according to the settings in the
"Search Setup"
dialog box. Tap the
icon and then tap the diagram with the waveform to be searched, or drag a rectangle to
define a search gate. The search is performed on the selected waveform.
Cursor
Performs a cursor measurement. T
apping the icon opens the overlay menu, where you
select the cursor type and source.
Operating the instrument