R&S RTO6 - Page 918

Protocol analysis
R&S
®
RTO6
918User Manual 1801.6687.02 ─ 05
Remote command:
SEARch:
TRIGger:MPHY:
CREDit:CONDition on page 2311
SEARch:TRIGger:MPHY:CREDit:MIN on page 2311
SEARch:TRIGger:MPHY:CREDit:MAX on page 2311
PACP Begin
Sets the specified PACP Begin to be searched for. The PACP Begin setup consists of
the condition and one or two PACP Begin patterns.
"Condition"
Defines the operator to set a specific PACP Begin, e.g. "Equal" or
"Not Equal"
or a range.
"Data Min/Data"
Defines the bit pattern of the data value pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor
, see
Chapter 13.1.7, "Bit pattern editor", on page 493.
"Data Max"
The second PACP Begin pattern is required to specify a range with
conditions "In range" and "Out of range".
Remote command:
SEARch:TRIGger:MPHY:
PBEGin:CONDition on page 2312
SEARch:TRIGger:MPHY:PBEGin:MIN on page 2312
SEARch:TRIGger:MPHY:PBEGin:MAX on page 2312
PACP Function ID
Sets the specified PACP Function ID to be searched for. The PACP Function ID setup
consists of the condition and one or two PACP Function ID patterns.
"Condition"
Defines the operator to set a specific PACP Function ID, e.g. "Equal"
or "Not Equal"
or a range.
"Data Min/Data"
Defines the bit pattern of the PACP Function ID pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor
, see
Chapter 13.1.7, "Bit pattern editor", on page 493.
"Data Max"
The second PACP Function ID pattern is required to specify a range
with conditions "In range" and "Out of range".
Remote command:
SEARch:TRIGger:MPHY:
PFID:CONDition on page 2313
SEARch:TRIGger:MPHY:PFID:MIN on page 2313
SEARch:TRIGger:MPHY:PFID:MAX on page 2313
Errors
Sets the type of error events to be searched for.
Reserved Bit Error ← Errors
Searches for reserved bit error.
M-PHY and USB SSIC (option R&S RT
O6-K580 and K570)