R&S RTO6 - Page 917

Protocol analysis
R&S
®
RTO6
917User Manual 1801.6687.02 ─ 05
"Condition"
Defines the operator to set a specific CRC, e.g. "Equal" or "Not
Equal"
or a range.
"Data Min/Data"
Defines the bit pattern of the CRC pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor
, see
Chapter 13.1.7, "Bit pattern editor", on page 493.
"Data Max"
The second CRC pattern is required to specify a range with condi-
tions "In range"
and "Out of range".
Remote command:
SEARch:TRIGger:MPHY:
CRC:CONDition on page 2309
SEARch:TRIGger:MPHY:CRC:MIN on page 2309
SEARch:TRIGger:MPHY:CRC:MAX on page 2310
Req
Sets the specified Reset Link Request (RReq) or Credit Transmit Request (CReq) to
be searched for.
RReq is used for requesting the remote end to reinitialize its Transmit (TX) Physical
Layer (PHY) while CReq is used for requesting flow control information for the corre-
sponding TC from the remote end.
"Data"
Defines the bit pattern of the RReq pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor
, see
Chapter 13.1.7, "Bit pattern editor", on page 493.
Remote command:
For "RReq":
SEARch:TRIGger:MPHY:
RREQ on page 2310
For "CReq"
SEARch:TRIGger:MPHY:CREQ on page 2310
Credit
Sets the specified credit to be searched for. The credit setup consists of the condition
and one or two credit patterns.
Credit represents the total number of credits available since boot time.
"Condition"
Defines the operator to set a specific credit, e.g. "Equal" or "Not
Equal"
or a range.
"Data Min/Data"
Defines the bit pattern of the credit pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor
, see
Chapter 13.1.7, "Bit pattern editor", on page 493.
"Data Max"
The second credit pattern is required to specify a range with condi-
tions "In range"
and "Out of range".
M-PHY and USB SSIC (option R&S RT
O6-K580 and K570)