R&S RTO6 - Page 2409

Remote control commands
R&S
®
RTO6
2409User Manual 1801.6687.02 ─ 05
EYE<m>:DISPlay:PERSistence:INFinite <State>
If persistence is enabled (EYE<m>:
DISPlay:PERSistence:
STATe), each new data
point in the diagram area remains on the screen infinitely until this command is set to
OFF.
Suffix:
<m>
.
1..4
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
EYE<m>:DISPlay:PERSistence:RESet
Resets the display, removing persistent values.
Suffix:
<m>
.
1..4
Usage: Event
Asynchronous command
EYE<m>:DISPlay:PERSistence:STATe <State>
If enabled, each new data point in the diagram area remains on the screen for the
duration defined using EYE<m>:DISPlay:PERSistence:
TIME, or as long as
EYE<m>:DISPlay:PERSistence:INFinite is enabled.
If disabled, the signal value is only displayed as long as it actually occurs.
Suffix:
<m>
.
1..4
Parameters:
<State> ON | OFF
*RST: ON
Usage: Asynchronous command
EYE<m>:DISPlay:PERSistence:TIME <Time>
If persistence is enabled (EYE<m>:
DISPlay:PERSistence:STATe), each new data
point in the diagram area remains on the screen for the duration defined here.
Suffix:
<m>
.
1..4
Protocols