R&S RTO6 - Page 1439

Remote control commands
R&S
®
RTO6
1439User Manual 1801.6687.02 ─ 05
Setting parameters:
<ZoomName> Defines the name of the zoom diagram to be copied.
<XOffset> Defines an offset to the existing zoom area in x direction.
<YOffset> Defines an offset to the existing zoom area in y direction.
Usage: Asynchronous command
LAYout:ZOOM:POSCoupling <DiagramName>, <ZoomName>, <PositionCoupl>
LAY
out:ZOOM:POSCoupling? <DiagramName>, <ZoomName>
Enables or disables the position coupling of coupled zooms. If position coupling is
enabled and one zoom area is moved, the other coupled zoom areas are moved, too,
and keep their distance.
Parameters:
<PositionCoupl> ON | OFF
*RST: OFF
Parameters for setting and query:
<DiagramName> String with the name of the diagram on which the zoom is based
<ZoomName> String with the name of the zoom diagram
Usage: Asynchronous command
LAYout:ZOOM:HORZ:MODE <DiagramName>, <ZoomName>,<Mode>
LAY
out:ZOOM:HORZ:MODE? <DiagramName>, <ZoomName>
Defines whether absolute or relative values are used to specify the x-axis values.
Since the zoom area refers to the active signal, relative values ensure that the zoom
area remains the same.
Parameters:
<Mode> ABS | REL
Mode used to specify the x-axis values of the zoom area.
*RST: ABS
Parameters for setting and query:
<DiagramName> Name of the diagram on which the zoom area is based.
<ZoomName> Name of the zoom diagram
Example: See Chapter 24.3.1.2, "Creating zoom diagrams", on page 1261
Usage: Asynchronous command
LAYout:ZOOM:HORZ:ABSolute:POSition <DiagramName>,
<ZoomName>,<Position>
LAY
out:ZOOM:HORZ:ABSolute:POSition? <DiagramName>, <ZoomName>
Defines the x-value of the centerpoint of the zoom area.
Waveform analysis