R&S RTO6 - Page 2545

Remote control commands
R&S
®
RTO6
2545User Manual 1801.6687.02 ─ 05
POWer:SWITching:SWIT <MeasSwitchingFreq>
Activates or deactivates the measurements of the switching frequency
.
Parameters:
<MeasSwitchingFreq>
ON | OFF
*RST: ON
POWer:SWITching:COND <MeasureConduction>
POWer:SWIT
ching:NCON <MeasureNonConduction>
POWer:SWITching:TON <MeasureTurnOn>
POWer:SWITching:TOFF <MeasureTurnOff>
POWer:SWITching:TOTal <MeasureTotal>
Enables the measurement during the respective period.
Parameters:
<MeasureTotal> ON | OFF
*RST: ON
POWer:SWITching:GATE:COND:STARt <T1>
POWer:SWIT
ching:GATE:COND:STOP <T2>
POWer:SWITching:GATE:NCON:STARt <T3>
POWer:SWITching:GATE:TOFF:STARt <T2>
POWer:SWITching:GATE:TOFF:STOP <T3>
POWer:SWITching:GATE:TON:STARt <T0>
POWer:SWITching:GATE:TON:STOP <T1>
Sets the value for the respective cursor.
Parameters:
<T1>
POWer:SWITching:RESult:ENERgy:ACTual? <MeasType>
POW
er:SWITching:RESult:ENERgy:AVG? <MeasType>
POWer:SWITching:RESult:ENERgy:EVTCount? <MeasType>
POWer:SWITching:RESult:ENERgy:NPEak? <MeasType>
POWer:SWITching:RESult:ENERgy:PPEak? <MeasType>
POWer:SWITching:RESult:ENERgy:RMS? <MeasType>
POWer:SWITching:RESult:ENERgy:STDDev? <MeasType>
POWer:SWITching:RESult:ENERgy:WFMCount? <MeasType>
Return the specified statistic result of the specified measurement type.
●
[:ACTual]: current measurement result
●
AVG: average of the long-term measurement results
●
EVTCount: number of measurement results in the long-term measurement
●
NPEak: negative peak value of the long-term measurement results
●
PPEak: positive peak value of the long-term measurement results
Power analysis (option R&S RT
O6-K31)